Horner APG RX371 OCS HERX371C101 - Manual (Page 39)

MAN0924-01-EN CH.9
February 8, 2010 Page 39 of 124 # 1018
CHAPTER 9: SMARTSTACK I/O
Note: Because the configuration parameters are different for each SmartStack Module, refer to the data
sheet that is sent with the product and is specific to the selected module.
9.1
Configuration Procedures
Note: SmartStack Modules use Cscape Software for configuration. RX371 supports metal smartstack
modules and can connect upto 4 modules.
1.
From the Main Menu, select Controller | I/O Configure.
Note: The look of the screen varies depending upon the type of controller that appears.
2.
First, ensure that the desired controller is selected.
In this case, a different controller than the one shown on the screen might be desired. It is
necessary to select the desired controller, which is the RX-371. In this example configuration.
Continue with Step 2.
However, if you are satisfied with the controller selection, press a Base # tab. Go to Step 3
Figure 9.1: Main Configuration I/O Screen
Note: The Auto Config System button can be pressed prior to selecting the desired controller and I/O.
By pressing the button, the current configuration from the local ID is uploaded and any current settings
are overwritten. A dialog box appears and indicates that settings will be deleted from currently configured
models. If OK, press Yes. Then press OK.