I2c connections, C connections – Matrix Orbital LK162-12 User Manual
Page 8
4
2. Make the connections.
a. Connect the four pin female header of the Communication/Power Cable to the
Communication/Power Header of your LK162-12/VK162-12.
b. Insert the male end of your serial cable to the corresponding DB9 header of the
Communication/Power Cable and the mate the female connector with the desired
communication port of your computer.
c.
Select an unmodified floppy cable from a PC power supply and connect it to the power header
of the Communication/Power Cable.
3. Create.
Use uProject or a terminal program to get started, and then move on with your own
development. A number of application notes are availab
I
2
C Connections
A more advanced connection to the LK162-12/VK162-12 is provided by the I
2
C protocol setting. This is
best accomplished using a breadboard and the Breadboard Cable. Power must be supplied from your
breadboard or another external source. To dive right into your application and use the LK162-
12/VK162-12 in I
2
C mode, get started with the guidelines below.
1. Set the Protocol Select switches.
I
2
C: Ensure that the two I
2
C jumpers in the corresponding protocol box are connected while all
others are open.
2. Make the connections.
a. Connect the Breadboard Cable to the Communication/Power Header on your LK162-12/VK162-
12 and plug the four leads into your breadboard. The red lead will require power, while the
black should be connected to ground, and the green and yellow should be connected to your
controller clock and data lines respectively.
b. Pull up the clock and data lines to five volts using a resistance between one and ten kilohms on
your breadboard.
3. Create.
This time you're on your own. While there are many examples within the Matrix Orbital
AppNote section
too many controllers and languages exist to
cover them all. If you get stuck in development, it is possible to switch over to another protocol
on the standard board, and fellow developers are always on our forums for additional support.