Atmel STK502 - Manual (Page 12)

Using the STK502 Top Module
2-6 STK502 User Guide
2528A–AVR–11/02
2.4 JTAG Connector Figure 2-8 shows how to connect the JTAG ICE probe on the STK502 board.
Figure 2-8. Connecting JTAG ICE to the STK502
The JTAG connector is used for the ATmega169 built-in JTAG interface. The pin out of
the connector is shown in Figure 2-9 and is compliant with the pin out of the JTAG ICE
available from Atmel. Connecting a JTAG ICE to this connector allows On-chip Debug-
ging of the ATmega169.
More information about the JTAG ICE and On-chip Debugging can be found in the AVR
JTAG ICE User Guide, which is available at the Atmel web site, www.atmel.com.
Figure 2-9. JTAG Connector
TCK
TDO
TMS
VTG
TDI
GND
VTG
RST
NC
GND
JTAG
1 2