AEG LAVAMAT 86740 - Manual (Page 37)

Instructions for use
37
Conditioner has not
rinsed, compartment
æ for care agent is
filled with water. Conditioner insert in the
compartment for care agent
is not properly placed on or
is blocked.
Clean detergent drawer, seat
conditioner insert properly.
Washing is badly
creased. Probably too much washing
has been put in.
Note maximum filling quan-
tity (see programme tables).
For easy-care textiles select
the EASY IRON (STRIJKVRIJ,
SANS REPASSAGE) pro-
gramme.
The washing has not
been spun as dry as
usual. The washing was not able to
be distributed evenly in the
drum prior to spinning. Always load the drum as ful
as possible with a combina-
tion of large and small items.
Washing is not spun.
Remaining water is vis-
iblein the drum.
Error code
(2
appears
.
There is a kink n the drainage
hose.
Remove kink.
Maximum pump height
(emptying height 1m from
base surface of the appli-
ance) is exceeded.
Refer to the customer
service. For pumping heights
over 1m, they have a supple-
mentary set as special spares
available.
Water pump is blocked.
Switch off appliance and pull
out electric plug. Clean wa-
ter pump.
At the siphon connection: Si-
phon is blocked.
Clean siphon.
Door cannot be opened
when appliance is
switched on.
Door is locked for safety rea-
sons (display DOOR/LIGHT is
Off). Wait till display DOOR/LIGHT
(DEUR/LICHT, PORTE/ECLAIR.)
lights up green.
Programme security is
switched On.
Cancel programme security
(see section „Programme se-
curity“).
Detergent remains
form inthe washing
powder/liquid drawer.
Water tap is not fully
opened.
Open water tap fully.
Filter in the socket of the in-
flow hose at the water tap or
the appliance is blocked.
Close water tap. Disconnect
inflow pipe from water tap
and from the appliance and
clean filter.
Problem Possible cause Remedy