APW Wyott Heated Pump/Dispenser CCW MK VII - 120V - Manual (Page 4)

Operating
NOTE
1. Clean the dispenser and pump according to the cleaning instructions before using the first
time.
2. This dispenser Is Intended for heating food by the double-boiler method. Product purchased
in a No.10 size can may be heated in the original can. Be sure to remove the top first. If
contents of No.10 can are not to be completely used in a day, the optional stainless
container, Part No. 43593-50 is recommended. This container will not rust as the
commercial can does.
Putting food directly Into the dispenser is not recommended as It might scorch and stick. In
addition, the pump suction tube will be about 1 1/8" short of the bottom.
3. Put 2 1/2 cups of water Into the pot (do not overfill) making certain the spider (16) is in place
before putting in either the can or the container of food.
4. Plug power cord Into appropriate, grounded outlet.
: Increase or decrease the temperature as required; the settings are In approximately
12°F increments, a value. which will change slightly with ambient temperature and voltage. If
a specific temperature Is required, use a product thermometer. After setting, allow 30
minutes for temperature to stabilize. Stirring will speed stabilizing. Remember, thick
materials such as cheese or fudge conduct heat poorly.
If the dispenser steams noticeably, the temperature setting should be reduced.
CLEANING THE DISPENSER
CLEANING THE PUMP
NOTE:
Warning:
Refer to the pump Instructions for cleaning the pump.
1. The outer shell of the dispenser is stainless steel. Wipe it
with a clean, damp cloth and mild detergent.
Avoid abrasive cleaners which can damage the stainless steel finish. Do not
immerse the heated dispenser in water or damage to the electrical parts or shock
hazard could occur.
2. Wash the inside of the dispenser with detergent and water, but DO NOT IMMERSE. Rinse
well but avoid spraying water in control knob opening or around the lighted display.
3. Prepare a sanitizing solution according to the Sanitizing. Guidelines. Place the solution Into
the container for about 10 minutes. Pour it out and allow the dispenser to air dry. Do not touch
the Inside of the container after sanitizing it.
Clean the pump daily according to the following instructions. Note the way the pump comes apart, so you
can reassemble it In reverse order.
1. Remove the spout plug (10) with its O-ring (11).
2. While holding the pump with lid upright, (as it is on the warmer), unscrew, counterclockwise,
the retaining nut (3) and lift out the knob (1), piston rod (2), seal (4), O-ring (5) and spacer
(32).
3. While still upright, lift off pot cover (19) and thread It over the spout.
4. Still upright, remove plug (8) with its O-ring (9).
5. Tip the pump body weldment (22) to remove balls (7) and spring (6).
6. Exercising care not to nick or scratch any surface, separate the seal and O-rings, (4), (5), (9),
and (11), from the mating steel parts.
7. Wash all parts thoroughly in detergent and water using the brush provided; rinse in hot water.
Wash seal and O-rings separately from metal parts to avoid damage to the soft seal and O-
ring surfaces. Avery small nick can cause a large leak.
8. Reassemble the pump and lid using reverse procedure. Be sure to replace the spring tang
down.
4