Acnodes RMC 7182 - Manual (Page 50)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2005 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7182
1U Rackmount System
Chassis Intrusion
The Chassis Intrusion header is des- ignated JL1.
Attach an appropriate cable from the chassis to
inform you of a chassis intrusion when the chas- sis
is opened
Wake-On-LAN
The Wake-On-LAN header is desig- nated JWOL
on the serverboard. See the table on the right for
pin defini- tions. You must also have a LAN card
with a Wake-On-LAN connector and cable to use
this feature.
External Speaker/Internal Buzzer
On the JD1 header, pins 1-4 are for an external
speaker and pins 3-4 are for the internal speaker. If
you wish to use an external speaker, connect it to
pins 1-4 to. If you wish to use the onboard speaker,
you should close pins 3-4 with a jumper.
Overheat/Fan Fail LED
The JOH can be connected to an LED to pro-
vide warning of chassis overheat. This LED will
also blink to indicate a fan failure. Refer to the table
on the right for pin definitions.
LAN1/LAN2 (Ethernet Ports)
Two Ethernet ports (designated JLAN1 and JLAN2)
are located be- side the VGA port on the I/O back-
plane. These ports accept RJ45 type cables. A
dedicated IPMI LAN is also located above the USB
0/1 ports for an IPMI network connection.