General, Setting the sleep timer, Sound adjustment – Aiwa CSD-TD28 User Manual

Page 9

Advertising
background image

SETTING THE SLEEP TIMER

The unit can be turned off automatically at a specified
time.

1

Keep REPEAT/SLEEP pressed until “30”
flashes in the display.

2

Within 4 seconds, press

r or t to

specify the time until the power is turned
off.

Each time it is pressed, the time changes between
10 and 90 minutes in 10-minute steps.

To check the time remaining until the power is
turned off

Repeat step 1 shown above. The remaining time is
displayed for 4 seconds.

To cancel the sleep timer

Display the remaining time and press

r

or

t

repeatedly until OFF is displayed.

NOTE

If the unit is turned off during tape playback,

x

on the

deck will not be released. Press

Z

to release

x

.

ENGLISH

9

En

SOUND ADJUSTMENT

Volume or tone adjustment does not affect recording.

VOLUME (VOL)

Press VOLUME

N

or

M

. The volume level is

displayed as a number from 0 to MAX (25).

• The volume level is automatically set to 14 if the

power is turned off when the volume level is set to
15 or more. (except when turning the power back
on within 4 seconds)

• Pressing DISPLAY on the remote control displays

the adjusted volume level (CSD-TD66 only).

3-MODE EQUALIZER

Press * 3-MODE EQUALIZER repeatedly until the
desired mode is displayed.
The equalizer mode changes to R (Rock), P (Pop),
J (Jazz) or no equalization, cyclically.

Rock

- Emphasizes the high and low range of music.

Pop

- Emphasizes voice and midrange of music.

Jazz

- Emphasizes the low range of music.

* or EQ on the remote control (CSD-TD66 only)

T-BASS system

The T-BASS system enhances the realism of low-
frequency sound.
Press T-BASS and the T-BASS indicator lights up.

QSOUND system

This system provides a rich, three dimensional sound
area for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.

• At higher volumes, turning QSOUND on may cause

sound distortion. In this case, make the volume
down.

Specified time

While the sleep timer works,
the dot keeps flashing.

GENERAL

Maintenance

To clean the cabinet

Use a soft cloth lightly moistened with mild
detergent solution. Do not use strong solvents such
as alcohol, benzine or thinner.

To clean the heads

When the tape heads are dirty;

- high frequency sound is not emitted
- the sound is not adequately high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on

After every 10 hours of use, clean the tape heads
with a head cleaning cassette.
Use separately sold dry-type or wet-type cleaning
cassette.
Refer to the instructions of the cleaning cassette for
details.

To clean the lens

Use a cotton swab slightly
moistened with cleaning
fluid. Wipe gently from the
center to the edge.

Lens

Advertising
This manual is related to the following products: