LBL Lighting Fusion Jack 1.5" Low Profile Canopy - Manual (Page 3)

3
EDGE OF
THE PORT
WIRE NUT
Place the wire nut connections and the port wires
properly inside the port. Make sure that the port and low
voltage wires are cleared from the edge of the port.
#6-32 SCREW
BACK RING
Replace the back ring onto the port so that end of the
wing screws are properly place into the two blind holes.
Replace and tighten the #6-32 set screws to secure the
back ring onto the port.
Push the port completely into the hole.
WING SCREW
WING
WING SCREW
WING SCREW
PHILLIPS SCREWDRIVER
Tighten the two phillips screws with a Phillips screwdriver
(an electrical screwdriver will speed up the process) until
the wings secure the port into the hole.
Replace and tighten the cap.
Repeat steps 1 through 13 for each port.
CAP
BACK RING
CONDUIT
WING
2D
8
8
9
10
11
11
10
9
10
12
12
12
2F
2E
2G
13
14
13