Samlex America ADJ-28 - Manual (Page 9)

8 | SAMLEX AMERICA INC. SAMLEX AMERICA INC. | 9
Section 3 | installation
10. Fig. 9 corresponds to one possible tilt-angle. Other tilt-angles maybe possible by
using different hole combinations.
Travelling mode
11. The mounting hardware should be connected in the tilted position only when the
RV is stationary. When the RV is in motion, the mounting hardware should be in
the flat mount position.
12. In order to do this remove the ¼”-20 x 1" carriage bolt carriage bolts by loosening
the ¼” wing nuts at points B and C (Fig. 9).
13. Lower the 28” mounting rails and the 14” brackets so that the square holes of
each set of the mounting rails and brackets align with each other and the solar
panel is flat (Fig. 10).
14. Using the ¼”- 20 x 1" carriage bolts and the ¼” wing nuts, secure the structure in
this position (Fig. 10).
Fig. 10 Travelling Mode
Point C Point A
Point B
Solar Panel
28” Mounting Rail
28” Mounting Rail
RV Roof