Campbell Scientific 25458 DIN-Rail Terminal Kit - Manual (Page 5)

25458 DIN-Rail Terminal Kit
1. Introduction
The 25458 kit can facilitate wiring when many wires need to be connected to
one terminal. The kit contains one 15906 5-inch DIN-Rail Mounting Bracket,
two 505 screws, two 6044 grommets, and two 15908 DIN-Rail Stoppers. A
complete configuration will also include #15920 Terminal Strips, #15907 End
Plates, and #15909 Jumpers. The stoppers, terminal strips, and end plates are
mounted onto the DIN Rail bracket. The DIN Rail bracket is mounted to an
enclosure backplate using the kit’s screws and grommets.
One 15920 terminal strip consists of three spring-loaded "guillotine" terminals
that provide connection points for individual wires. Up to 20 of these terminal
strips may be fastened to the DIN Rail bracket. The 15907 End Plates separate
the terminal strips. The 15909 jumpers are used to electrically connect the
terminals. A stopper needs to be on each end of the terminal strip assembly.
2. Installation Procedure
1. Mount the 15908 DIN Rail Stoppers, 15920 Terminal Strips, and 15907
End Plates onto the 15906 DIN Rail Bracket (see Figures 1 through 3).
FIGURE 1. 15908 DIN Rail Stopper Installation
1