Campbell Scientific CM300-series Mounting Poles - Manual (Page 9)

CM300 Series Mounting Poles
3.4 CM300 Series Mounting Pole with Pedestal Legs
A CM300 series pole with a Pedestal Leg option can be used for temporary
installations or for applications where a concrete foundation is not an option.
The “Short” Pedestal Legs are adequate for most applications. The “Long”
Pedestal Legs provide additional stability for applications where the feet cannot
be secured (e.g. to the surface of a roof), for extended poles, or for locations
with high winds.
Each leg attaches to the pedestal base with two bolts. The pedestal base has a
set of three holes for each leg. The angle of the legs, and resultant pedestal
height, is determined by which hole the end bolt is placed through (see table in
Section 2).
Attach the legs to the pedestal base, and tighten the bolts (do not over-tighten).
Place the pole into the base and tighten the six bolts evenly. For additional
stability, the feet can be spiked to the ground using (3) PN 17049 Ground
Spikes, or secured with user-supplied anchors through the holes in the feet.
CM300 Series Pole
Ground Lug
Pedestal Legs
FIGURE 4. CM300 Mounting Pole with Pedestal Legs
5