Campbell Scientific RF500M Radio Modem - Manual (Page 23)

Section 4. Operation of the Radiotelemetry Network
FIGURE 4-2. LoggerNet Setup Screen - Schedule Tab
4.1.4 General Communication – LoggerNet Connect Screen
General communications include: collect data, send and retrieve programs,
monitor measurements in real time, graph real time data, etc. The LoggerNet
Connect screen supports these general communication tasks. Communication
can only be done after the RF communication path has been setup in the Setup
screen. To communicate with the datalogger, open the Connect screen and
click on the button that corresponds with the type of communication needed.
The Collect Now or Custom buttons will collect data from the datalogger. The
Send and Receive buttons will send a program to the datalogger or receive a
program from the datalogger respectively. The Check Clocks and Set Station
Clock buttons will check and set the datalogger clock to match the computer
clock. The Graphs section has three buttons used to launch graphs of real time
data. The Numeric section has three buttons used to open displays of numeric
real time data.
4-3