Campbell Scientific SC-USB USB to CS I/O Optically Isolated Interface - Manual (Page 5)

SC-USB Table of Contents
PDF viewers: These page numbers refer to the printed version of this document. Use the
PDF reader bookmarks tab for links to specific sections.
1. Introduction..................................................................1
2. Technical Specifications.............................................2
2.1 USB Specifications...................................................................................2
2.2 CS I/O Port Specifications........................................................................2
2.3 General Specifications ..............................................................................3
2.4 Ships With ................................................................................................3
3. Using SC-USB Driver and Setup CD ..........................3
3.1 Drivers Installation ...................................................................................3
3.1.1 Windows 7 ......................................................................................4
3.1.2 Windows Vista..............................................................................14
3.1.3 Windows 2000/XP........................................................................17
3.1.4 Windows 98/98SE/ME .................................................................20
3.1.5 Uninstalling the SC-USB Drivers .................................................22
3.1.6 Determining which COM Port the SC-USB has been Assigned ..22
3.2 Set-up Modes – the SC_USB Programming Utility ...............................24
3.2.1 Settings..........................................................................................24
3.2.1.1 Auto Detect (Automatic Baud Rate Detection)...................24
3.2.1.2 Selecting a Fixed Baud Rate ...............................................25
3.2.1.3 Enable All Comms Modes (Automatic Mode Detection) ...25
3.2.1.4 Enable CSDC Address 7 Mode...........................................25
3.2.1.5 Enable CSDC Address 8 Mode...........................................25
3.2.1.6 Enable SDC Comms Mode .................................................25
3.2.1.7 Enable ME Comms Mode ...................................................26
3.2.1.8 Set ID ..................................................................................26
3.2.2 Operating System (OS) Downloads..............................................26
4. Using the SC-USB with Campbell Software and
Hardware .................................................................26
4.1 LoggerNet EZSetup or Standard Setup ..................................................26
4.2 Using the Device Configuration (DevConfig) Utility ............................26
4.2.1 Accessing DevConfig ...................................................................26
4.2.2 Downloading a Datalogger OS .....................................................27
4.3 Use with the DSP4..................................................................................27
5. Troubleshooting ........................................................27
5.1 Installation ..............................................................................................27
5.2 Software Settings....................................................................................27
5.3 Electronic Interference............................................................................28
i