Campbell Scientific TGA100 Trace Gas Analyzer Manual - Manual (Page 112)

112
Parameter Menu: File Format Parameters
---------------------------------------------
File format: ASCII (0) or binary (1) 1 [0..1]
Concentration File Decimation Factor 1 [1..864000]
Interval to start new data files (min) 0 [0..10080]
European date format (0=no, 1=yes) 0 [0..1]
Site Means and Gradients to printer 0 [0..1]
Printer Code 0 [0..3]
Read data from additional device? 0 [0..2]
Output conc to additional device? 0 [0..1]
Parameter Menu: File Save Selection Parameters
---------------------------------------------
Data to Save to Disk
-----------------------
[X] 10 Hz Gas Conc (graph: 0.00 to 1.00 ppm)
[ ] Mean Gas Conc (graph: 0.00 to 1.00 ppm)
[ ] Gas Conc StDev (graph: 0.00 to 10.00 ppb)
[ ] Laser Temp (graph: -40.00 to 40.00 K )
[ ] Laser Heater (graph: 0.00 to 15.00 V )
[ ] Laser DC Current (graph: 0.00 to 0.00 mA )
[ ] Pressure (graph: 0.00 to 100.00 mb )
[ ] Valve Status (graph: 0.00 to 256.00 )
Dual Ramp Data to Save to Disk
-----------------------
[ ] 10 Hz GasB Conc (graph: 0.00 to 1.00 ppm)
[ ] Mean GasB Conc (graph: 0.00 to 1.00 ppm)
[ ] GasB Conc StDev (graph: 0.00 to 10.00 ppb)
[ ] 10 Hz DelGasB (graph: -1.00 to 1.00 ш/м)
[ ] Mean DelGasB (graph: -1.00 to 1.00 ш/м)
[ ] DelGasB StDev (graph: -1.00 to 1.00 ш/м)
[ ] Ramp B Offset (graph: -10.00 to 10.00 mA )
[ ] Ref Det Signal B (graph: 0.00 to 60.00 mV )
[ ] Ref Det Trans B (graph: 0.00 to 100.00 % )
[ ] Smp Det Signal B (graph: 0.00 to 60.00 mV )
[ ] Smp Det Trans B (graph: 0.00 to 100.00 % )