Figures – Wesley BCT-6200-6SA User Manual
Page 7
Curtis 1243
GEN
2 Manual,
Rev. B
vii
FIGURES
FIG
. 1: Curtis 1243
GEN
2 electronic motor controller ........................... 1
FIG
. 2: Mounting dimensions, Curtis 1243
GEN
2 controller ................ 4
FIG
. 3: Basic wiring configuration, Curtis 1243
GEN
2 controller ........... 7
FIG
. 4: Wiring for 5kΩ–0 throttle (“Type 1”) .................................... 10
FIG
. 5: Wiring for 20kΩ potentiometer used as
a wigwag-style throttle (“Type 1”) .......................................... 10
FIG
. 6: Wiring for 0–5V throttles (“Type 2”) ..................................... 11
FIG
. 7: Wiring for current source throttle (“Type 2”) ........................ 12
FIG
. 8: Wiring for 3-wire potentiometer throttle (“Type 2”) .............. 12
FIG
. 9: Wiring for Curtis ET-XXX electronic throttle (“Type 2”) ..... 13
FIG
. 10: Wiring for 0–5kΩ throttle (“Type 3”) .................................... 14
FIG
. 11: Wiring for fault outputs ......................................................... 15
FIG
. 12: Wiring for Curtis Spyglass display .......................................... 15
FIG
. 13: Ramp restraint maps for controller with the minimum
field set at 3 amps, maximum field at 18 amps, and
braking current limit at 300 amps ......................................... 24
FIG
. 14: Electromagnetic brake parameters, in the context
of the four delay parameters ................................................... 29
FIG
. 15: Effect of adjusting the throttle deadband parameter .............. 33
FIG
. 16: Effect of adjusting the throttle max parameter ................ 34, 35
FIG
. 17: Throttle maps for controller
with maximum speed set at 100%
and creep speed set at 0 ......................................................... 36
FIG
. 18: Throttle maps for controller
with maximum speed set at 100%
and creep speed set at 10% ................................................... 37
FIGURES