Maximum Wireless Mini-Max - Manual (Page 3)

Page 3
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
MINI-MAX
INSTALLATION
WIRELESS
RECEIVER
7
TRANSMITTER
Move the active temperature transmitter as close as possible to
your preferred final mounting location. Also move the MINI-MAX
indicator and receiver combination as close as possible to their
final mounting location. Select a location for the transmitter that
is protected from direct sunlight and sheltered from rain or
physical damage. A North exposure, six feet above the ground
will give the best results. Check to make sure that proper
communication between the transmitter and receiver still exists
by verifying that the light on the receiver is still flashing GREEN
every four seconds. NOTE: If more than 15 minutes has passed
since the test button on the temperature transmitter was pushed,
it will need to be pushed again. If the signal has been lost, move
the transmitter to an alternate mounting location and re-check
for proper communication.
GREEN
Once proper communication between the transmitter and receiver
is verified, final installation of the transmitter can be made.
Remove the four screws on the sides of the mounting bracket
and remove the bracket from the transmitter housing. Attach
the mounting bracket to the wall using the four stainless steel
mounting screws supplied in the hardware package. Once the
bracket is installed simply re-attach the transmitter housing to the
bracket using the four screws initially removed to separate the bracket
from the housing.
BRACKET
MOUNTING
SCREWS
30
40
-3 0
- 0 3
- 2 0
0 -2
- 1 0
0
1 0
2 0
0 5
60
7 0
8 0
9 0
1 0
1 1 1 2
-1 0
0 10
2 0
3 0
4 0
Fahr enh eit
Celsiu s
8