Maximum Wireless Merlin - Manual

YELLOW BROWN
MERLIN
INSTALLATION
THIS MANUAL IS DESIGNED TO LEAD YOU STEP BY STEP THROUGH THE PROCEDURES REQUIRED
TO TEST, INSTALL AND USE YOUR WIRELESS MERLIN. BY FOLLOWING THESE PROCEDURES AND
SETTING UP THE SYSTEM CORRECTLY IN THE BEGINNING, YOU WILL BE ABLE TO ENJOY ALL THE
FEATURES OF YOUR WIRELESS MERLIN FOR YEARS TO COME. WE STRONGLY SUGGEST THAT
YOU PERFORM A TRIAL WIRING OF YOUR WIRELESS MERLIN PRIOR TO FINAL INSTALLATION.
1
0
0
0
0
1 Locate the NiCad Batteries and Battery charger, then charge the
batteries according to the charger instructions. You will need them
later. The NiCad batteries will be kept charged by the solar panel
when installed in the transmitter. They should not need replacement
for two to three years. When they do need replacement use 1000
milliamp/hour NiCad batteries. (Do NOT use Alkaline or NiMH
batteries.)
WIRELESS
YELLOW BROWN
WHITE
GREEN RED
WHITE
GREEN
RED
2
You now need to wire your receiver to your display unit.
Connect the
and wires from the RECEIVER
to the power terminals on the back of the MERLIN (the
polarity does not matter). Connect the wires from the 12 volt
power supply to the same power terminals (again the polariity
does not matter). Connect the
wire from the RECEIVER
to TERMINAL #1 and the BLACK wire from the RECEIVER to
TERMINAL #2 on the rear of the MERLIN indicator.
RED GREEN
WHITE
2 1
OUT G D N IN
5 4 3
WHITE
GREEN
RED
MERLIN
RECEIVER
12 VOLT
POWER
SUPPLY
RECEIVER WIRING
YELLOW
3
Feed the and wires from the Wireless
Wind Transmitter through the small access hole in one of the
black rubber boots. Using the solid brass nuts from the
Hardware Pack, attach the wires to the two terminals on the
Wind Speed Sensor (no polarity). Do NOT adjust the nuts that
YELLOW BROWN
SMALL HOLE
IN BOOT
WIRELESS
TRANSMITTER
WIRES
BOOT
BRASS
NUT
BRASS
NUT
Page 1
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
POWER
TERMINALS
GREEN
RED
WHITE WHITE .............to...............TERMINAL #1
BLACK............to...............TERMINAL #2
.................to........Power (no polarity)
............to........Power (no polarity)
RED
GREEN
AND
YELLOW BROWN YELLOW
WIRES
AND
are already on the sensor.
BROWN
BROWN
BLACK
BLACK
BLACK