Maximum Wireless Maestro (2006-2012) - Manual (Page 3)

MAESTRO
INST TION ALLA
WIRELESS
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
Page 3
1000
1000
7
Open the battery compartment by removing the stainless
steel screws in the cover. Insert the two 1000 Milliamp
batteries that have been fully charged per the
charger instructions. The test light in the wireless
transmitter will blink once to indicate that the batteries
have been installed properly.
Ni-Cad
1000 MILLIAMP
NI-CAD BATTERIES
WIRELESS
TRANSMITTER
1000
1000
TEST LIGHT
TEST
BUTTON
8
Plug in the 12 volt power supply that is connected to the
instrument and the receiver Test the transmitter by depressing
the test button. After a few seconds the test light should blink
every two seconds. This indicates that the transmitter is in test
mode, which lasts for 15 minutes. At the end of 15 minutes the
transmitter will return to normal operating mode.
.
After initial
power up, the indicator light on the receiver should blink red
every two seconds. This indicates proper communication
between the receiver and the wind transmitter. (NOTE: If more
than 15 minutes has passed since the button on the wind
transmitter was pushed it will need to be pushed again.) The
light on the receiver will blink other colors when different sensors
are installed.
TEST LIGHT
2 1
OUT GND IN
5 4 3
RECEIVER
12 VOLT
POWER SUPPLY
TRANSMITTER
RECEIVER
INDICATOR
ORANGE
RED
GREEN
TRANSMITTER
RED
GREEN
ORANGE
....................WIND
................RAIN
.........TEMPERATURE