Bodyline Products International AXIS AIR SHAVER AX-5330 - Manual (Page 10)

Axis Air |1| english Axis Air |1| english
While the shaver is recharging, a small continuous noise may be heard
or the shaver body or the AC adaptor may build up and emit some
heat. This is not a malfunction.
After recharging
> After the shaver is recharged for approximately 1 hour, all the power
reserve indicator LEDs and the recharge indicator LED will remain lit
up, indicating that the shaver is fully charged.
> After recharging, be sure to pull out the power cord plug of the AC
adaptor from the outlet.
* When unplugging the AC adaptor, do not pull the power cord,
as this may cause a malfunction. Be sure to hold the plug when pulling
it out.
USING YOUR SHAVER
WITH THE AC POWER SUPPLY
Checking to see that the power switch is off, insert the power cord of
the AC adaptor securely into the socket at the bottom of the shaver,
and then, insert the outlet plug into the outlet. Then, slide the power
switch on.
> With the shaver connected to the AC adapter, should the shaver not
operate by sliding the power switch on, the rechargeable battery is
completely depleted. In this case, slide the power switch off, allow
the shaver to charge for 1 minute, and then slide the power switch
back on again.
> After each use, make sure to slide the power switch off, and
then unplug the AC adapter from the outlet and from the shavers
recharging socket.
> If your environment is humid, such as a bathroom, do not use the
shaver with its AC power supply.