Samsung DTB-B360 - Manual (Page 46)

Refer
ence
Operating The Receiver
GB-27
GB
GB-26 D i g i t a l T e r r e s t r i a l R e c e i v e r
TROUBLESHOOTINGS
Problem Possible cause Solution of the problem
No display LED on Power cord Power cord plug in correctly
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode; Set receiver to “On”;
Scart not connected tightly Check connection and correct;
to video output of television;
incorrect channel or video
Check channel and video output and
output selected on television correct (TV instruction manual)
No sound Audio cord connected Check connection and correct;
incorrectly;
Loudness level = 0;
Increase loudness on television set;
Muting active Press the MUTE key
Remote Control does not Incorrect operation; Point remote control
operate directly towards the Receiver.
Batteries dead or inserted Replace batteries or insert correctly
incorrectly
Poor picture quality Signal strength too low Check the signal strength in
the “Manual Scan” menu, correct
alignment of your antenna
On-Screen Error Message Antenna cable not connected Check connection and correct;
“Searching for signal” or not tight;
incorrect position of the
Check position and correct,
antenna; Check the signal strength in
the “Manual Scan” menu
On-Screen Error Message Receiver not yet set Scanning of in “Installation” menu
“Channel data does not
exist.”
The device, packaging material (e.g. Styrofoam) and the batteries must never be
disposed of with household refuse. Please obtain appropriate information about the
regulations in your community, and dispose of all refuse in accordance with regulations
at the separate locations provided.
In some region, the digital terrestrial signal may be weak.
So you’d better use the antenna in which the booster was built, for watching the
weak signal channels.
You can download and upgrade the system software of the receiver through
a specific channel designated by the broadcaster.
The Distributor will provide you with more information about that.
DISPOSAL
OPERATING THE RECEIVER
4.5 Software Update
Using this function, you can check if a new version of the
software is available and upgrade the software if available.
● To upgrade the software, select ‘OK’ and press the OK
key.
● Selecting this will take about 2 minutes to check if a new
version of the software is available. If a new version is
available, the software upgrade starts.
● If there is no new version, the “You don’t need to
upgrade software!” message appears.
● To cancel the upgrade, select ‘Cancel’ and press the
OK key.
MD68-00296A_GB 4/27/06 2:11 PM Page 26