Amcor AM90 User Manual
Page 9
GB
9
FILTERS IN AM90
The HEPA Type Filter:
a. The HEPA Type Filter is recognised by the pleated fi lter material being covered by
an active carbon fi lter on one side and an Accelerant Deoderisation fi lter on the
other side. All of the filter layers are fitted into a plastic filter frame.
b. The HEPA Type Filter assembly is for one time use. It cannot be washed. It
should be replaced after about 8 months of normal use.
c. The replacement HEPA Type Filter assembly can be purchased from your AM90
supplier or Amcor.
ROUTINE SERVICE AND CLEANING
Regular maintenance of the unit will keep it operating at maximum effectiveness.
CAUTION: To reduce the risk of injury, unplug the unit before cleaning or filter
servicing.
Unit cleaning
Clean the outside of the unit at least once a week with a damp paper towel
moistened with a common household detergent.
Cleaning the area around the unit
It is recommended to wipe the area around the air purifier once a week with a wet
paper towel in order to remove any accumulation of dust.
Model:
AM90
Mains:
220-240 V / 50 Hz
Current:
0.25 Amps
Ozone:
Much lower than International safety limits.
Installation:
No installation required.
Power Consumption: 45 W (High blower speed)
Fan Speed:
High, Medium and Low
Coverage:
40 m
2
Dimensions:
370 x 180 x 500 mm (W x D x H)
Airflow rate:
High speed: 150 m
3
/h
Net Weight:
4.5 kg
Ionisation
Total negative ion output:
2.5 x 1012 = 2.5 trillion negative ions per second.
* Subject to changes without notification.
TECHNICAL DATA