ATEN VS-881 - Manual (Page 10)

Installation
Installation is simply a matter of plugging in cables.
1. Make sure that power to all the devices you will be
connecting up have been turned off.
2. Plug the monitor or digital projector cable into the
unit’s Monitor port.
3. Plug one end of a video cable (see the System
Requirements section on p. 3), into any available
video port on the unit; plug the other end into the
computer’s video output port.
Note: One video cable is supplied with this unit.
Additional cables require an extra purchase.
4. Plug the power adapter (supplied with this package)
into an AC source; plug the power adapter cable into
the unit’s Power Jack.
5. Plug the IR Receiver cable into the IR Receiver port at
the front of the main unit.
6. Power On all equipment.
- 8 -
2002-12-13