Step 4: connect drain hose to drain receptacle – Alliance Laundry Systems TLW12CTLW12C User Manual

Page 11

Advertising
background image

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Installation

9

202068

Step 4: Connect Drain Hose to Drain
Receptacle
Drain Facilities

IMPORTANT: The drain hose installation is a very

important factor in the washer installation. If care

is not taken when the drain hose is installed, a

siphoning action can be started which will cause

water to be siphoned from the washer during the

cycle.

End of drain hose should never be in water as

siphoning action can be started that will cause

water to be siphoned back into the washer.
The curved end of drain hose MUST be installed

even with or above the height of the cabinet top of

the washer to prevent siphoning. Refer to Figure 6.

The standpipe or drain receptacle must be capable of

handling a minimum of 1-1/2 inches (3.8 cm) outside

diameter drain hose. The drain hose should fit loose

within the standpipe (it should not be snug fit). Never

install the drain hose into a “sealed” drain system as

air cannot escape and will restrict the water from being

drained from the washer. A sealed drain system may

also allow water to be pumped back into the washer

during agitation. Both of these conditions may result

in flooding of the washer.
Remove the drain hose from its shipping position on

the rear of the washer by unhooking the hose from the

retainer clamp.

If necessary, follow the instructions for your type of

drain receptacle (high standpipe or low standpipe) to

properly install the drain hose.

High Standpipe Installation

NOTE: No. 562P3 Siphon Break Kit and No. 25863

Hose Coupling are not required for this type of

installation.

Figure 7

IMPORTANT: Drain receptacle must be capable of

handling a minimum of 1-1/2 inch (3.8 cm) outside

diameter drain hose.

W294I

1

Drain Hose

2

Standpipe

Figure 6

W294I

2

1

RECOMMENDED

STANDPIPE

HEIGHT

36 inches
MINIMUM

(91.44 cm)

W296I

1

Drain Hose

2

Cut Drain Hose off at This End to Fit the
Washer Installation

3

Standpipe

{

W296I

3

1

MAXIMUM

STANDPIPE

HEIGHT NOT TO

EXCEED 5 feet

(1.5 m)

2

Advertising