AudioControl DQS - Manual (Page 19)

Owner’s Enjoyment Manual
The Strength of Digital
™
Figure 6: DQS main menu screen
➊ ➊ ➊ ➊ ➊ ➋ ➋ ➋ ➋ ➋ ➌ ➌ ➌ ➌ ➌ ➍ ➍ ➍ ➍ ➍
15
Front EQ Freq = 1kHz Front EQ Freq = 1kHz Front EQ Freq = 1kHz Front EQ Freq = 1kHz Front EQ Freq = 1kHz
L= +6dB
L= +6dB L= +6dB L= +6dB L= +6dB >o< >o< >o< >o< >o< R =+4dB R =+4dB R =+4dB R =+4dB R =+4dB
MODE: Front EQ, Rear EQ, SubCtr EQ
Figure 7: Graphic EQ Screen
Your DQS has 30 built-in graphic equalization
filters for each channel. These frequencies happen
to match those on the AudioControl SA-3055 real
time analyzer. In the Graphic EQ mode, you can
select any of the 30 frequencies, one at a time, and
apply boost or cut. The menu screens for your
graphic equalizers are labeled Front EQ, Rear
EQ, and SubCtr EQ respectfully. In addition you
can select whether you want the equalization
controls to affect the left and right channels
individually or control both channels at the same
time.
Freq(uency): This corner of the screen indi-
cates which frequency you are boosting or cut-
ting. If you wish to select another frequency, tap
the left or right arrow buttons
until the cursor is flashing on
the number next to “Freq=”.
Then use the “+” and “-” controls
to select the frequency to which
you wish to apply boost or cut.
1) Digital Status Display - This cool blue
screen will tell you which mode your DQS is in.
2) Select - Every time you tap this button, you
will scroll through the various modes in your
DQS.
3) “+” and “-” Navigation Buttons:
Depending upon where your cursor is flashing,
these buttons will allow you to change the fre-
quency, apply boost/cut and vary the bandwidth
or “Q” of your equalization filters.
4) Left and Right Navigation Buttons:
Within each mode there are several sub functions
(i.e. Freq., Lvl, Width, etc.) that you can access
using these buttons. By tapping on these buttons
and watching the flashing cursor, you can navi-
gate through each
function on the
screen.