Ashly MX-206 - Manual (Page 10)

Page - 10 Operator Manual – MX-206 Mixer
Copyright© 2006 – Ashly Audio Inc.
Specifications
SPECIFICATION MX-206
DISTORTION
THD at +20 dBu, 20Hz-20KHz, input switch at -40dB <0.05%
IMD (SMPTE) at +20dBu, input switch at -40dB <0.02%
HUM & NOISE (20Hz-20KHz , input switch at -60dB)
Equivalent input hum and noise <-127dBu
Residual output noise, TRS outputs, all levels at minimum <-100dBu
Residual output noise, XLR outputs <-90dBu
Master Level at nominal, all Ch. Level controls at min <-84dBu
Master Level and one Ch. Level at nom <-80dBu
MAXIMUM VOLTAGE GAIN (±2dB)
Mic Input to Master Output, 600 ohm load <-84dB
Aux In to Master Output <-34dB
Frequency Response - 20Hz-20Khz +0/-0.5dB
Crosstalk - between any inputs or outputs 20Hz-20KHz <-60dB
VU METERS - Two 6-segment LED meters 0VU = +4dBu
PEAK INDICATORS
Peak Clip indicator on each input channel and left and right
outputs, illuminates 3dB below clipping
PHANTOM POWER
+48 VDC applied to all Mic Inputs, switchable on front panel.
Maximum total current draw = 80mA.
Maximum single channel current draw = 14mA.
Gradual power-up and down to eliminate"pops".
SHIPPING WEIGHT 13 lbs. Maximum
POWER REQUIREMENTS 100-240 Volts, 50-60 Hz, 30 watts
Unless otherwise stated, specification conditions are: 150
source, Input set at "-40", all
other controls set at nominal.
Safety Instructions – 3
Introduction - 4
MX-206 Mixer – 5
Connectors & Cables – 5
Physical Description - 6
Installation – 7
Typical Applications - 8
Troubleshooting - 9
Dimensions - 9
Specifications - 10
Warranty - 11