Aiwa AV-NW31 - Manual (Page 12)

En
ENGLISH
12
RADIO RECEPTION
PRESET TUNING
You can preset up to 32 stations and tune them in directly .
PRESETTING STATIONS
1 Tune in the desired station.
2 Press ENTER to store the station.
The preset number , beginning from “ 1 ” appears on the display .
3 Repeat steps 1 and 2 to store other stations.
The next station will not be stored if a total of 32 preset stations
have already been stored. (“
FULL ” is displayed.)
TUNING IN PRESET STATIONS
1 Turn FUNCTION to select FM or AM.
2 Turn MULTI JOG to select a preset number.
Alternatively , press i or k on the remote control.
You can tune in the desired preset station directly by pressing
the numbered buttons on the remote control.
- To select preset number 1 1, press +10 and 1.
- To select preset number 25, press +10, +10 and 5.
To clear a preset station
1 Tune in the station by preset tuning.
2 Press ENTER, and press ENTER again while the frequency
flashes on the display .
Alternatively , press ENTER or C on the remote control, and
press ENTER while the frequency flashes on the display
.
MANUAL TUNING
MULTI JOG
TUNER
MODE
0-9,+10
C
SHIFT
FUNCTION
ENTER
TUNING
INPUT MODE
POWER 6 STANDBY/ON
i / k / j / l
ENTER
1 Turn FUNCTION to select the desired band; FM
or AM.
2 Press TUNING N N N N N / M M M M M to tune in a station.
Alternatively , press j or l on the remote control.
“ TUNE ” is displayed when a station is tuned in.
“ 1 ” is displayed for FM stereo reception.
To search for a station automatically (Auto search)
Hold down TUNING N or M (or j or l ).
The unit searches for a station and stops at reception.
To stop the search manually , press TUNING
N or M (or j or
l ).
• Auto search may not stop at stations with weak signals.
When an FM stereo broadcast contains noise
Hold down SHIFT and press TUNER MODE on the remote control
so that “
MONO ” is displayed.
Noise is reduced, although reception is monaural.
To cancel, repeat the above so that “
STEREO ” is displayed.
When the reception contains noise interference
Move the unit away from other electrical appliances, especially
digital audio devices, or turn of
f the appliances that generate
noise signals.
To switch the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Hold down INPUT MODE and press POWER
6 STANDBY/ON.
To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
RADIO RECEPTION