Astone Holdings Pty high quality speaker system - Manual (Page 7)

Reference Reference
Power Rating
Power Supply
Frequency response
Weight
Input Requirement
Satellite speakers
Subwoofer
Dimensions
Total 10 Watts RMS
External AC Adapter (100 - 240V)
60Hz - 20KHz
28.9oz / 820g
Main Connection iPod docking connector
Auxiliary connection - 1 / 8” (3.5mm) mini stereo jack
2 x 2.5 Watts (4 ohm)
30mm drivers
1 x 5 Watts (8 ohm)
2.5” dedicated low frequency high excursion driver
6.1” x 6.9” x 5.7” (width x height x depth)
155mm x 176mm x 145mm (width x height x depth)
Maintaining the system
Changing the remote control battery is the only regular maintenance that is required. You may also clean the
system as needed.
To replace the remote control battery
Replace the remote control battery when it stops operating (normally every year or two), or its range seems
reduced. Use only a Duracell, Eveready, Energizer, Maxell, Toshiba, or Shun Wo CR2032 3-volt lithium battery.
Keep in mind that lighting and other room conditions, in addition to battery age, can affect the operating range
of an infrared remote control.
To clean the system
Wipe the system using a soft dry cloth. You can also lightly vacuum the grille.
• Do not use solvents, chemicals, or sprays.
• Do not allow liquids to spill or objects to drop into any openings.
Specifications
Troubleshooting
What to do Problem
Your iPod does not dock
properly
Check whether there is any barrier in the iPod jack or not.
Check whether the direction of iPod jack pins are all the same or not.
•
•
No sound Make sure the system is plugged in, your iPod is turned on, and a music track is
selected and playing.
Press the PLAY / PAUSE button on the remote control.
Increase the volume setting for the system.
Remove your iPod from the dock, wait briefly, then reseat it. You may need to do
this a few times.
•
•
•
•
No sound and your iPod
is not charging
Make sure the power cable is securely plugged into a functioning outlet and with
the DC plug plugged firmly into the DC input jack.
Make sure your iPod is firmly seated in the dock.
•
•
Your iPod does not respond
to the i-Ballroom remote
control buttons shown
Remove your iPod from the dock, wait briefly, then reseat it. You may need to do
this a few times.
Try the remote from a different location. If it works there, strong lighting or other
room conditions may be causing the problem.
Make sure nothing blocks the infrared (IR) signal path from the remote to your
i-Ballroom system. wipe off the small red lens on the front send of the remote.
Check the remote control battery to make sure the + side is up.
Replace the remote control battery.
•
•
•
•
•
No sound, or cacophony
when using the FM function
Check the antenna to make sure it has already been plugged into the matched
jack.
Check the system to make sure the FM function has been turned on.
•
•
Low sound Check the system to see whether the volume is adjusted to the smallest status or
not.
Check the audio source to see whether the output is too small or not.
•
•
Your i-Ballroom system does
not respond to its remote
commands or to the + and
volume buttons on the front
of the system
Unplug the power cable for 1 minute, then plug it back in. This resets the system.
Contact ASTONE Customer Service about the problem.
•
•
www.astone.com.au www.astone.com.au 10 11