Annual service, Cleaning outer surfaces, Cleaning the glass – Aarrow Fires Becton 7 mk3 User Manual

Page 21: Servicing

Advertising
background image

ANNUAL SERVICE

THIS GAS APPLIANCE MUST BE SERVICED
EVERY TWELVE MONTHS BY A QUALIFIED
GAS ENGINEER.

See "SAFETY NOTICES" ref coal set page 4.

Ensure the appliance is cold.

Step 1 Isolate the gas supply to the fire using

the gas cock supplied at installation.

Step 2 Open the fire door, (Held closed using a

magnet).

Step 3 Remove the glass frame and the glass/

gasket assembly.

Step 4 Carefully remove and clean the coal set of

any soot deposits using a soft brush.

Step 5 Carefully remove and clean the firebox

linings. Where necessary.

Step 6 Inspect the chimney and flue terminal

ensuring they are in good working order
and sweep as necessary to ensure no
debris blocks the flue. Please note
periodic chimney sweeping is vital to gas
fire maintenance.

Step 7 Remove matrix location plate and valve

heat shield. Clean any soot deposits from
inside the fire using a vacuum cleaner.
See “Safety notes”on page 4.

Step 8 Inspect the pilot assembly to ensure that it

is clean, unobstructed and in good order.

Step 9 Check system for gas soundness.

Step 10 Replace heat shield and matrix location

plate.

Step 11 Replace fire box linings.

Step 12 Replace coal set.

Step 13 Replace glass/gasket and glass frame and

close the fire door.

Step 14 Carry out spillage test as per instructions
on page 16.

CLEANING OUTER SURFACES

To clean the outside first the appliance must be
cold.

The outside finish of the fire is a durable high
temperature paint, this will give off a slight odour
during the first few days of operation. It is best
cleaned by using a soft brush. Do not allow
moisture to remain on the fire whilst cold or surface
rust may occur.

CLEANING THE GLASS

To clean the glass the appliance must be cold.

Step 1 Open the fire door. (This is held closed using
a magnet)

Step 2 Remove the glass frame and the glass/gasket
assembly (See page 19).

Take care not to damage the glass or gasket when
cleaning.

Step 3 Replace glass frame and the glass/gasket
assembly. Close the fire door.

Becton Bunny & Becton 7 mk3 Gas stoves

21

SERVICING

Advertising
This manual is related to the following products: