Acer 5210 - Manual (Page 86)

Chapter 4 77
Monitor type does not match
CMOS - Run Setup Run Load Default Settings in BIOS Setup Utility.
Shadow RAM Failed at offset:
nnnn BIOS ROM
System board
System RAM Failed at offset:
nnnn DIMM
System board
Extended RAM Failed at offset:
nnnn DIMM
System board
System battery is dead -
Replace and run Setup Replace RTC battery and Run BIOS Setup Utility to
reconfigure system time, then reboot system.
System CMOS checksum bad -
Default configuration used RTC battery
Run BIOS Setup Utility to reconfigure system time, then
reboot system.
System timer error RTC battery
Run BIOS Setup Utility to reconfigure system time, then
reboot system.
System board
Real time clock error RTC battery
Run BIOS Setup Utility to reconfigure system time, then
reboot system.
System board
Previous boot incomplete -
Default configuration used Run Load Default Settings in BIOS Setup Utility.
RTC battery
System board
Memory size found by POST
differed from CMOS Run Load Default Settings in BIOS Setup Utility.
DIMM
System board
Diskette drive A error Check the drive is defined with the proper diskette type
in BIOS Setup Utility.
See External Diskette Drive Check.
Incorrect Drive A type - run
Setup Check the drive is defined with the proper diskette type
in BIOS Setup Utility.
System cache error - Cache
disabled System board
CPU ID: System board
DMA Test Failed DIMM
System board
Software NMI Failed DIMM
System board
Fail-Safe Timer NMI Failed DIMM
System board
Device Address Conflict Run Load Default Settings in BIOS Setup Utility.
RTC battery
System board
Allocation Error for device Run Load Default Settings in BIOS Setup Utility.
RTC battery
System board
Error Message List
Error Message FRU/Action in Sequence