Night Guard Home Surveillance System RS-725LCD - Manual (Page 20)

20
2. Before turning off the engine, press and release and buttons at the same
time.
-- The LED will flash indicating the remote start has entered the turbo charge mode.
3. Take the “Ignition Key” from the key cylinder.
-- Engine keeps running. --
4. Exit and secure the vehicle.
-- Engine continues running until the pre-programmed time elapsed. --
NOTE: This feature only applies to vehicles with Turbo Engines.
E. TIMER START:
This unit can be programmed to start and run the engine every 3 hours or punctually
at the same time next morning, the engine will run for the programmed running time
and then shut down.
IMPORTANT: Timer Start should be used only in open areas, never start and run the
vehicle in on enclosed space as a garage or carport.
Daily Timer Start: The feature is very useful for the driver who wants to run the
vehicle punctually at the same time next morning. Before set-up of the “Daily Timer
Start”, you should set you time for engine start.( see Timer Setting / Timer set-up for
“Daily Timer Start, page 21)
ENTER:
1. Press the button once to remote start the vehicle. As soon as the vehicle is
running and the parking lights have turned on or are flashing.
2. Immediately depress the button once, within 2 seconds
3-a. 3 Hours Timer Start: Rapidly depresses the button (or depresses +
buttons, if you program + buttons = Start / Stop button.) The parking light will
flash (3) times. The siren or horn chirps (3) times. The vehicle is now programmed
to start every 3 hours.
3-b. Daily Timer Start: Depress the transmitter button
first, within 3 seconds press ( ) button. The parking
light will flash (6) times. The siren chirps (6) times. The
vehicle is now programmed to start at the real time of the
next day. Your set time for the next day engine start flashes
for approx. 3 seconds on the LCD screen. After 3 seconds
the icon stays displayed on the LCD screen.
4. Press the brake pedal to stop the vehicle running.
Exit the timer start: Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. The LED and parking light will flash (4) times. The horn chirps (4)
times. Or
1. Press the button twice to remote start the vehicle. As soon as the vehicle is
running and the parking light have turned on or flashing.
2. Immediately depress the button then press and hold the button for 2 seconds.
(or depresses + buttons, if you program + buttons = Start / Stop button.)
The parking light will flash (4) times. The siren or horn chirps (4) times. The vehicle is
no longer programmed to start automatically.