Axxess Interface RFASWC User Manual
Page 11
4. If you have a different radio then Eclipse, press the Volume Up button
again till the led goes solid red, then release Volume Up. You have
now programmed Kenwood.
5. Here is the chart to show how many presses of the Volume Up button
is needed for which radio you are trying to program:
1st led flash is for Eclipse
2nd led flash is for Kenwood
3rd led flash is for Clarion
4th led flash is for Sony and Dual
5th led flash is for JVC
6th led flash is for Pioneer and Jensen
7th led flash is for Alpine*
8th led flash is for Visteon
9th led flash is for Valor
10th Clarion 5V
* Note: If the ASWC flashes 7 times and you do not have an Alpine
radio connected to it that means that the ASWC did not see any radio
connected. Verify the 3.5mm connector is connected to the SWC input on
the radio.
6. Once the radio manufacturer has been selected hold Volume Down
for at least 5 seconds. The led will flash the number of times which
radio was selected then the led will remain on to indicate the ASWC
has finished programming.
7) Go enjoy your radio.