Samsung SCH-I830MSASPR - Manual (Page 154)

146 Section 2H: Using Bluetooth Wireless Technology
6. Tap the name of the other device you want, and then
tap Next.
7. Enter a passkey, which should be between 1 and 16
characters, and tap Next.
8. Change the name of the device associated with the
bond, if desired, and then tap Finish.
Accepting a Bond
To accept an incoming bond:
1. Make sure that Bluetooth is turned on and the device is
discoverable.
2. When prompted to bond with the other device, tap Yes.
3. Enter a passkey, which should be between 1 and 16
characters and must match the passkey entered on the
originating device.
4. Tap Next.
5. Change the name of the device associated with the
bond, if desired, and then tap Finish.
Renaming a Bond
The rename a bond:
1. Make sure that the two devices are within range and
that Bluetooth is discoverable on both devices.
2. Tap the Start menu bar in the upper left hand portion of
your screen.
3. Tap Settings, and then tap the Connections tab.
4. Tap Bluetooth, and then tap the Devices tab.
5. Tap the bond you want to rename.
Note: You must enter the same passkey on both devices..