Samsung WF393BTPARA-A1 - Manual (Page 24)

24_ Washing a load of laundry
Deactivating the Child Lock function
Press and hold both the Spin and Soil level buttons simultaneously for approximately 6 seconds.
• When you deactivate the Child Lock function, the door is unlocked and the “Child Lock ” is turned off.
• The Child Lock function prevents children or the infirm from accidently operating the washer and
injuring themselves.
• If a child enters the washing machine, the child may become trapped and suffocate.
• Once you have activated the Child Lock function, it continues working even if the power is turned
off.
• Opening the door by force can result in injury due to damage to the product.
To add laundry after you have activated the Child Lock function, you must first pause or deactivate the
Child Lock function.
If you want to open the door of the washing machine when the Child Lock function is activated:
• Pause or deactivate the Child Lock function.
• Turn the washing machine off and then on again.
Garment+
You can add or take out laundry items even after the wash has started, as long as the
“Garment+ ” light is on. Pushing the Start/Pause button unlocks the door, unless the water is
too hot or if there is too much water in your washer. If you are able to unlock the door and wish
to continue the wash cycle, close the door, and then press the Start/Pause button.
Delay Start
You can set the washing machine to start your wash automatically at a later time, choosing a delay time.
The hour displayed indicates the time at which the wash will be started.
1. Set your wash course.
2. Press the delay Start button repeatedly until the delay time is set.
3. Press the Start/Pause button. The “Delay Start ” indicator will be lit, and the clock will begin
counting down until it reaches the set time.
4. To cancel a Delay Start function, press the Power button and then turn the washing machine on again.
My Cycle
Allows you to activate your custom wash (temperature, spin, soil level, etc.) with one–button
convenience. By pushing the my Cycle button, you activate the settings used during the my
Cycle mode. The “My Cycle” light goes on, indicating activation. You can select all options as
follows in “My Cycle” mode.
1. Press the my Cycle button on the Control Panel.
2. Select the cycle using the Cycle Selector dial.
3. After cycle selection, set each option.
See page 37 for available option settings with each cycle.
4. Start “My Cycle” by pushing the Start/Pause button in “My Cycle” mode.
The washer will display the cycle and options you selected the next time you choose “My
Cycle”.
You can change the “My Cycle” settings by repeating the process above.
The washer displays the last settings used the next time you choose “My Cycle”.
To program “My Cycle” settings into your washer, the washer needs to complete an entire
wash cycle. If for any reason the wash cycle is interrupted and the washer does not finish
the cycle, it will not program in the settings for later use.
washing a load of laundry
WARNING
CAUTION
WF395BTPA-03145B-05_EN.indd 24 2013-12-13 10:26:49