Samsung XE700T1C-A04US - Manual (Page 74)

72 73
Chapter 3.
Using the computer
4
Select Save to save the changes.
5
If the system automatically restarts and the Samsung logo
screen appears, press the Home button
áᔪ
Ŗᮁ
᜽᯲
ᰆ⊹
ᖅᱶ
several times.
6
Select Security > TPM Configuration and set the TPM
Device item to Enabled.
Set the TPM State to Enable & Activate.
TPM Device
TPM State
Security Chip State
Aptio Setup Utility - Copy (C) 2012 American Megatrends, Inc.
Enabled
Enabled & Activate
Clear
Enabled & Activate
Deactivate & Disable
Clear
7
Select Save to save the changes.
8
The computer automatically restarts. Initialization of the TPM
chip has been completed. Now, install the TPM program and
register the TPM program.
Installing the TPM program
You can install the TPM program as follows. Install the program
according to the procedures below.
This program is only provided for models with Recovery and
the TPM function.
1
When the computer is off, press the Power button while
holding down the Volume (+) button.
Select Recovery to enter software recovery mode.
2
Select System Software. If the message box appears, click
Yes.
The computer boots up in Windows.
3
If you move to the Desktop screen, the SW Update program
runs.
Select TPM Host SW and click Install Now.
If the system software media is supplied with the product,
you can install the program by using the system software
media (only when supplied.)
4
After the installation, if you click OK, the computer restarts.
Using the TPM Security Device
(Optional)