Samsung LSA800SN-XAA - Manual (Page 7)

5
Français
Español
Deutsch
Italiano
English
Portuguese
Figure 3. Connecting your monitor to a PC
1 Turn off your system and unplug its power cord.
2 Place the FPD facedown on a cushion (being careful not to harm the screen) so that
you can access the cable connectors along the bottom of the rear recess.
3 When connecting your FPD to a computer: Connect the supplied signal cable to the
15-pin mini D-sub connector
Á
on the back of your FPD. Connect the other end of the
cable to the video port on the back of your computer.
When connecting your FPD to a workstation: Connect an optional signal cable to the
13W3 connector
Â
on the back of your FPD. Connect the other end of the cable to the
video port on the back of your workstation. An adapter may be required.
NOTE: One or both types of signal cables can be connected to the FPD,
simultaneously.
4 Connect the power adapter jack to the power port
¬
on the back of the FPD. To
prevent dislodging the jack, slide the power adapter cable into the cable holder. Insert
the cable holder into the holder slot and turn it 1/4 turn. Connect the proper power
cord for your locale to the AC inlet on the power adapter.
5 Place your FPD upright on your desk and plug the power cords from your system and
your FPD into a nearby outlet.
6 Turn on your system and FPD. If your FPD displays an image, installation is complete.
7 Perform the auto adjustment procedure as described in “Auto Adjustment” on page 6
1
To workstation
video port
2
3
4
5
6
Installation
sa800e2.fm Page 5 Monday, May 29, 2000 2:09 PM