Samsung I80 - Manual (Page 14)

01 READY
13 READY_
Connecting to a Power Source
Important information about USB cable usage.
å Use a USB cable (SUC-C3) with the correct specifi cation.
å If the camera is connected to the PC through a USB hub :
connect the camera directly to the PC.
å If the camera and other devices are connected to the PC at the
same time : remove other device.
å If the USB cable is connected to a port located on the front of the PC :
remove the cable and connect it to a port located on the back of the PC.
å If the USB port of the PC doesn’t meet the Power output standard
(4.2V, 400mA), the camera may not be charged.
Ê How to charge the rechargeable battery (SLB-1137D)
å Before inserting any cables or AC adapter, check the directions and
do not insert by force. It may cause breakage of cable or camera.
å If the charging LED of the AC Charger does not turn on or blink after
inserting the rechargeable battery, please check whether the battery
is inserted correctly.
å If you charge the battery with the camera power on, the battery won’t
be fully charged. Turn the camera off while charging the battery.
Ê Charging LED of the AC Adapter
Charging LED
Being Charged Red LED is on
Charging is complete Green LED is on
Charging error Red LED is off or blinking
Being discharged
(Using the AC adapter)
Orange coloured LED is on
å If you insert the fully discharged battery to charge it, do not turn on the
camera at the same time. The camera may not be turned on because
of the low battery capacity. Charge the battery for more than 10 min-
utes before using the camera.
å Do not use the fl ash frequently or take a movie clip with the fully
discharged battery charged for a short time. Even if the charger is in-
serted, the camera power may be turned off because the rechargeable
battery is discharged again.