Samsung NP540U4E-K01US - Manual (Page 77)

76
Chapter 3.
Using the computer
4
Select Save to save the changes.
5
When the computer restarts automatically and the Samsung
logo screen appears, press the F2 key repeatedly.
6
Select Security > TPM Configuration and set the TPM
Device item to Enabled.
Set the TPM State to Enable & Activate.
TPM Device
TPM State
Security Chip State
Aptio Setup Utility - Copy (C) 2012 American Megatrends, Inc.
Enabled
Enabled & Activate
Clear
Enabled & Activate
Deactivate & Disable
Clear
7
Select Save to save the changes.
8
The computer automatically restarts. Initialization of the TPM
chip has been completed. Now, install the TPM program and
register the TPM program.
Installing the TPM program
You can install the TPM program as follows. Install the program
according to the procedures below.
This program is only provided for models with Recovery and
the TPM function.
Method 1
1
Run Recovery and click on System Software.
- If your computer does not boot up or if System Software
does not display in the Recovery program, use Method 2
to install the TPM program.
2
Click on System Software Installation.
3
The SW Update program will be launched.
Select TPM Host SW and click Install Now.
If the system software media is supplied with the product,
you can install the program by using the system software
media (only when supplied.)
4
After the installation, if you click OK, the computer restarts.
Using the TPM Security Device
(Optional)