Setting up your french door refrigerator, Reverse osmosis water supply – Samsung RF266AEPN-XAA User Manual

Page 18

Advertising
background image

18_

Setting Up

4. Remove the filter cap and insert the filter into the filter

housing.

5. Slowly turn the water filter 90º clockwise to align with the

printing mark on the cover, locking the filter in position.

Make sure to align the water filter label mark with center of

cover filter printing as illustrated. Remember, do not over-

tighten.

You should remove the right side upper glass shelf before installing water filters.

Removing any residual matter inside the water
supply line after installing the water filter.

1. Turn ON the main water supply & turn OFF the valve to the

water supply line.

2. Run water through the dispenser until the water runs clear

(approx. 6-7 minutes). This will clean the water supply system

and remove air from the lines.

3. Additional flushing may be required in some households.
4. Open the Refrigerator door and make sure there are no water

leaks coming from the water filter.

Be sure to flush the dispenser thoroughly or water may drip from the dispenser.

This is due to the fact that there is still air in the line.

Setting up your French Door Refrigerator

Turn until the label

aligned.

Separation

of red cap.

Cover filter.

4

5

One Touch Pure Water

test button

In case ice doesn’t come out, pull out the ice bucket and press test button located on
the right side of ice maker.

Caution

test button

Reverse osmosis water supply

iMPoRtant : The pressure of the water supply coming out of a reverse osmosis system going to the

water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to
the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):

• Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if

necessary.

• Allow the storage tank on the reverse osmosis system to refill after heavy usage.
• If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction

with a reverse osmosis system. Remove the water filter.

If you have questions about your water pressure, call a licensed, qualified plumber.

DA68-01812F.indb 18

2010.10.14 3:47:2 PM

Advertising
This manual is related to the following products: