Samsung RF220NCTASP-AA - Manual (Page 11)

setting up _11
01
SETTING UP
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the fl oor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 286.6 lbs (130 kg).
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
ACCESSORIES AND REQUIRED
TOOLS
The following accessories are included with your
refrigerator:
Hex wrench
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
screwdriver(+)
Flat-blade screw
driver(-)
Socket wrench
(10 mm)
Pliers
Allen wrench
(3/16”) (5 mm)
REMOVING THE REFRIGERATOR
DOORS
Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
• Be careful not to drop, damage or
scratch the door/drawer while removing
them.
Be careful not to get injured while removing the •
door/drawer.
Reattach the door/drawer properly to avoid:
•
Moisture from air leakage. -
Uneven door alignment. -
Wasting energy due to improper door seal. -
Disassembling the fridge door
Be careful not to drop and scratch the
doors while removing the doors.
Remove the 3 screws holding down the top 1.
table and remove it.
Disconnect electric wire on the top of the 2.
refrigerator.
WARNING
WARNING
Top Table
DA68-02657A.indb 11 2012.7.3 10:53:27 AM