Samsung WF306LAW-XAA - Manual (Page 16)

C-5 SAMSUNG Clothes Washer Owner’s Instructions
FOR SILVERCARE™ WASHING (select models)
An increased consumer demand for energy-saving products prompted Samsung to develop a system to
use silver, widely known for its antimicrobial properties, as a sanitizing agent in your washing machine.
Pure silver atoms have an electron stripped away by electrolysis during the wash and rinse cycles, which
releases up to 16 million trillion silver ions that then penetrate deep into the fabric to sanitize clothing
(according to U.S. EPA Test Guideline DIS/TSS-13) without the need for hot water or bleach.
Here’s how it works: A grapefruit-sized device alongside the tub uses two pure silver plates the size of
large chewing gum sticks as electrodes in the water inlet system. The resulting positively charged silver
atoms - Silver ions (Ag+) -- are sprayed into the tub during the wash and final rinse cycle.
This process removed or killed greater than 99.9% of tested bacteria.
Samsung’s SilverCare™ Technology provides a 92% energy savings over hot water sanitization. Extra
delicate blouses, shirts, or even lingerie that can’t be washed in hot water can now be sanitized
effectively without the adverse effects of hot water sanitization that is normally a concern with those
types of articles. The silver plates carry a warranty of ten years, and can easily be replaced by a Service
Technician if so needed.
1. Load the washer.
2. Press the Power button.
3. Select a Cycle by turning the Cycle Selection dial.
4. Press SilverCare™ button.
5. Add detergent in the dispenser tray for main washing, and add fabric softener up to the marked line.
6. Press the Start/Pause button.
: The washer automatically selects optimal washing conditions by sensing the laundry’s weight.
Note :
FOR HOME USE ONLY– COMMERCIAL USERS SHOULD NOTIFY THEIR LOCAL WASTE TREATMENT
AUTHORITIES BEFORE USE
The total number of silver cycles run by the washer is displayed when pushing the Signal button and the
SilverCare™ button.
LU3 : less than 1000 times
LU2 : between 1000 to 2000 times
LU1 : between 2000 to 2999 times
LU0 : over 2999 times
You should replace the SilverCare™ kit when the display reads “LU0” as the electrodes are near the end of
their useful life. Contact 1-800-SAMSUNG.
Note :
For some models that have no heater if you choose SilverCare™, the temperature will be automatically
set to to Cold/Cold.
You cannot choose the SilverCare™ option with the Wool cycle.
Washing a Load of Laundry