Samsung HPS4253X-XAC - Manual (Page 12)

˛ P.MODE button
Adjust the TV picture by selecting one of the preset factory settings (or
select your personal, customized picture settings). (Refer to page 53)
◊ S.MODE button
Select Sound effect. (Refer to page 67)
± MTS button
Press to choose stereo, mono or Separate Audio Program
(SAP broadcast).
≠ SRS button
Activates TruSurround. (Refer to page 68)
– AUTO PROG. button
Press to display the memorized channels menu. (Refer to page 37)
— ADD/DEL button
Press to add or erase channels in the TV’s memory. (Refer to page 81)
÷ STILL button
Press to pause the current screen.
® P.SIZE button
Select Picture size. (Refer to page 56)
∑ PIP control buttons
SWAP: Interchange the main and sub picture.
CH
, : Displays the available channels in sequence.
(These buttons change channels in the PIP window only.)
µ CAPTION button
Controls the caption decoder.
¥ RESET button
If your remote control is not functioning properly, take out the batteries
and press the reset button for about 2~3 seconds.
Re-insert the batteries and try using the remote control again.
≥ SET button
Used during set up of this Samsung remote control, so that it will work
compatibly with other devices (VCR, Cable Box and DVD).
12
Installing the Batteries in Your Remote Control
1
Lift the cover at the back of
the remote control upward
as shown in the figure.
3
Close the cover as shown
in the figure.
2
Install two AAA size batteries.
Make sure to match the “+” and
“-” ends of the batteries with the
diagram inside the compartment.
• Do not mix battery types, i.e.
alkaline and manganese.
Remote Control Operation Range
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the TV’s remote control receiver.
Note
• This is a special remote control for the visually impaired, and has Braille points on the Power,
Channel and Volume buttons.
BN68-00991B-01Eng(002~031) 2/17/06 1:56 PM Page 12