Samsung LS19WJXSBV-XAA - Manual (Page 38)

changed after changing the
video card. Settings.
Has the video card been set
properly? Set the video card by referring to
the video card manual.
There is a message that
reads "Unrecognized
monitor, Plug & Play (VESA
DDC) monitor found". Have you installed the monitor
driver? Install the monitor driver
according to the
Driver
Installation Instructions .
See the video card manual to see
if the Plug & Play (VESA DDC)
function can be supported. Install the monitor driver
according to the
Driver
Installation Instructions .
Check the following items if there is trouble with the monitor.
1. Check if the power cord and the video cables are properly connected to the computer.
2. Check if the computer beeps more than 3 times when booting.
(If it does, request an a service for the main board of the computer.)
3. If you installed a new video card or if you assembled the PC, check if the installed the adapter
(video) driver and the monitor driver.
4. Check if the scanning ratio of the video screen is set to between 56 Hz ~ 75 Hz.
(Do not exceed 75 Hz when using the maximum resolution.)
5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode,
remove the Display Adapter at the "Control Panel→System→Device Administrator" and then
reboot the computer to reinstall the adapter (video) driver.
If problems repeatedly occur, contact an authorized service center .
Q & A
Question Answer
How can I change the
frequency? The frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version
of the driver used. (Refer to the computer or the video card
manual for details.)
How can I adjust the resolution? Windows ME/XP/2000 : Set the resolution in the Control Panel →
Display → Settings.
* Contact the video card manufacturer for details.
How can I set the Power Saving
function? Windows ME/XP/2000 : Set the function in the BIOS-SETUP of
the computer or the screen saver. (Refer to the Windows /
Computer Manual).
How can I clean the outer
case/LCD Panel? Disconnect the power cord and then clean the monitor with a soft
cloth, using either a cleaning solution or plain water.
Do not leave any detergent or scratches on the case. Do not let
any water enter the monitor.
Self-Test Feature Check
Self-Test Feature Check | Warning Messages | Environment | Useful Tips
Your monitor provides a self test feature that allows you to check whether your monitor is
functioning properly.