ArtDio IPS 1000 - Manual (Page 12)

IPS 1000 Series VoIP Gateway
12
Cut off the conductor outside the edge to avoid from
causing the circuit shortage
8. Information required before Installation
You need to prepare the following information before installing the gateway.
8.1. IP Address
The gateway requires an IP address for operation. Before installation you need to know how to obtain an
IP address from your local ISP. Static IP, DHCP or PPPoE can be used. The following table helps you to
decide what information you need. If your ISP offers static IP, you may need to obtain an IP from MIS
personnel in order to prevent an IP conflict. Otherwise DHCP (most cable broadband providers offer this)
and PPPoE (most ADSL broadband providers offer this) will work fine.
IP Environment Requiring information
Public IP
Address
IP Address
Subnet Mask
Default Gateway
It is strongly suggested that you obtain an
IP address from MIS personnel in order to
prevent an IP conflict.
Static IP
Private IP
Address
IP Address
Subnet Mask
Default Gateway
It is strongly suggested that you obtain an
IP address from MIS personnel in order to
prevent IP conflicts.
Your private IP requires an IP Sharing
device and you must configure the IP
Sharing device to treat the IPS unit and the
IP that it is using as a virtual server.
Dynamic IP address (DHCP) DHCP mode