Operating instructions, tips, Vent sensor (dv50f9a8e(g)*), The vent sensor detects any duct blockages – Samsung DV50F9A7GVP-A2 User Manual

Page 30

Advertising
background image

30_

operating instructions, tips

VEnT SEnSoR (DV50F9A8E(G)*)

Your Samsung dryer is equipped with a Vent Sensor, which detects and notifies you when it is time to clean

the ductwork. Keep your dryer safe and efficient by cleaning the ducts when prompted.

The Vent Sensor detects any duct blockages

You can fi gure out whether there is a duct blockage from the “Vent Sensor ” lamp of the

digital display.

Level

Message

Status

Solution

0

The “Vent Sensor

lamp is turned off .

The ductwork is free from

blockages.

-

1

The “Vent Sensor ”

lamp illuminates.

When a part of the duct

or the lint fi lter is blocked

by lint or a foreign object.

When the resistance is

high because the duct is

too long or bent.

Check the duct

connection and shorten

the duct and straighten it

if necessary.

Check the lint fi lter or

the duct and clean it if

necessary.

2

The “Vent Sensor ”

lamp blinks.

When the duct is blocked

by lint or a foreign object.

When the resistance is

very high because the

duct is too long or bent

excessively.

Check the duct

connection and shorten

the duct and straighten it

if necessary.

Check the lint fi lter or the

duct and clean it as soon

as possible.

In the LEVEL 2 state, this lamp blinks for 3 hours after the completion of the cycle. (If the wrinkle

prevention function is activated, this message is displayed for up to 3 hours.)

If the power button is pressed or the door is opened, the power is immediately turned off.

For more information about the duct installation, please refer to the “Ducting requirements”

section on page 10.
• Although the dryer is available even if the blockage message is displayed, the drying time

may be extended.
• If the LEVEL 1 message is displayed the fi rst time the dryer is run after the installation,

check the connection and clean the duct. If the LEVEL 1 message appears even

after you have checked and cleaned the ducts, this may indicate that there are some

restrictions of the duct due to the length, condition, etc.

If this occurs, you can use the dryer normally and no countermeasures need to be taken.

However, the drying time may be extended or the drying performance may be degraded.

operating instructions, tips

F900A DRY_DV50F_USER MANUAL_DC68-03170D-05_EN.indd 30

2014/3/18 15:00:06

Advertising