Samsung DVD-R135-XAA - Manual (Page 94)

94 - English
A
dditional
Information
Remote Control Unit
Read the table of contents and then
find and read the section describing
your problem, and follow the
instructions given.
Turn your DVD recorder off and on.
If the problem still persists, contact a
nearby Samsung service center.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Other problems
Point the remote control at the remote
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Check whether the batteries are
empty.
Checkpoint 1
Checkpoint 2
The remote control doesn't work.
A recorded disc is played with only
the subtitle and the audio signal
which were selected during recording.
Checkpoint 1
Is it possible to change a subtitle and an audio
signal on a recorded disc?
Other
Press the ( ) and ( ) buttons on
your DVD recorder simultaneously
when the power is on. All settings
including the password will revert to
the factory settings. Do not use this
unless absolutely necessary.
(Note that this function is possible only
when no disc is inserted.)
Checkpoint 1
I forgot my password for parental supervision.
Check your TV system setup
correctly.
Screen Jitter may occur when the
frame rate is converted from 50Hz to
60Hz for 720p/1080i HDMI (High
Definition Multimedia Interface)
Output.
Please refer to the user's manual of
your TV.
Checkpoint 1
Checkpoint 2
Checkpoint 3
HDMI output Jitter
R135-XAA-ENG-91-100 2006.3.11 10:2 AM Page 94