Samsung RF4267HAWP-XAA - Manual (Page 19)

Operating _19
02
O
PERA
TING
2. Tempered Glass shelves
To remove - Tilt up the front of the shelf in the
direction shown ( 1 ) and lift it up
vertically ( 2 ). Pull the shelf out.
To relocate - Tilt the front of the shelf up and
guide the shelf hooks into the slots
at a desired height. Then lower the
front of the shelf so that the hooks
can drop into the slots.
The Tempered Glass shelves are heavy.
Use special care when removing them.
3. Vegetable & Fruit Drawers
To remove - Pull the drawer out to full extension.
Tilt up the front of the drawer and
pull straight out.
To relocate - Insert the drawer into the frame rails
and push back into place.
The drawers need to be removed before the
glass shelf above them can be lifted out.
4. Flex Zone
To remove the Flex Zone – Pull the Flex door out
to full extension. Lift the Flex Zone up, pulling it to
your body with both hands.
To relocate the Flex Zone – Open the Flex door to
full extension. Tilt the front of the Flex Zone up,
place the back of the Flex Zone onto the rails,
and then lower the front until the whole Zone
rests on the rails.
When the Flex Zone or LED lighting are not
working, check the connectors [ ( 1 ), ( 2 )
shown below] for cracks or leaks.
1. Refer to page 7 for disassembly instructions.
2. Open the cover housing with a flat-blade
screwdriver.
Using the doors
Ensure that the doors close all the way and are
securely sealed.
When the refrigerator door is only partially open,
1
2
CAUTION
CAUTION
1
2
DA68-02481A-11.indb 19 13. 12. 4. �� 3:35