Samsung RS275ACRS-XAA - Manual (Page 17)

17
INST
ALLA
TION INSTR
UCTIONS
INSTALLATION OF THE REFRIGERATOR
Check the dimensions of your entrance door to determine whether the refrigerator can pass through it.
• Select a location with easy access to the water supply.
• Select a location with enough space for the refrigerator.
• Select a location which is not exposed to sunlight.
• Select a location with level floor.
• Before disassembling the freezer door, the water supply line needs to be disconnected.
(If not, the water supply line can be damaged.)
• See “Separating the water supply line from the refrigerator” on the next page.
Checking the Dimensions of your Entrance Door
Selecting the Location for the Refrigerator
How to assemble the separable door handle
● Allow clearance to the right, left, back and the top when installing the
refrigerator. This has the advantage of reducing power consumption.
● Do not install the refrigerator where the temperature will go below
50°F(10°C).
Allow sufficient space to circulate the air in the internal cooling system.
• If the refrigerator does not have enough space, the internal cooling system
may not work correctly.
2inches
0.1inch
2 inches
NOTE
NOTE
Dimension
(inches)
Width
Capacity (Cu. Ft)
Model RS275 / RS277
26 1/2
without Hinge
Case Height
with Hinge
with door
Depth
without door
35 7/8
68 1/2
70
33 13/16
30 1/2
- Make sure the “UP” mark on the rear
of the handle is facing right side up.
- Match the upper and lower Handle
Locking Tabs on the doors to the
handles.
Fix the handles to the doors
by sliding them down firmly. - Check the installation of the handles
by pulling them.
- If the handles are inserted properly,
they should not move.
DA99-01506A(EN)-0.0 2008.3.17 3:14 PM 페이지17 in