Samsung HW-F750-ZA - Manual (Page 11)

11
ENG
●
CONNECTIONS
CONNECTING THE WIRELESS SUBWOOFER
The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect
wirelessly) automatically when the main unit is turned on. If the LINK indicator does not light when the main
unit and subwoofer are turned on, please set the ID by following the procedure below.
ƒ
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
ƒ
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the
STANDBY LED on the upper side will come on after the LINK indicator (Blue LED) blinks for 30
seconds.
ƒ
If you use a device that uses the same frequency (2.4GHz) near the system, interference may
cause some sound interruption.
ƒ
The transmission distance of the wireless signal between the main unit and subwoofer is about
33 ft., but may vary depending on your operating environment. If a steel-concrete or metallic
wall is between the main unit and the wireless subwoofer, the system may not operate at all,
because the wireless signal cannot penetrate metal.
ƒ
If the main unit doesn't make a wireless connection, follow steps 1-5 above to retry the
connection between the main unit and wireless subwoofer.
ƒ
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from
water and moisture.
ƒ
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
1. Plug the power cords of the main unit and subwoofer into an AC wall outlet.
2. Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.
• The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.
ID SET
POWER TV POWER
AH59-02545A
TV VOL TV CH AUDIO SYNC
SOURCE
REPEAT
SoundShare
AUTO POWER SPEAKER TV SOURCE
TV PRE-CH VT DIMMER
SMART VOLUME SOUND EFFECT
S/W LEVEL S/W LEVEL
VOL
VOL
3D SOUND PLUS DRC
TV MUTE TV INFO
MUTE
SMART VOLUME SOUND EFFECT
S/W
LEVEL
S/W
LEVEL
VOL
VOL
3D SOUND
PLUS
DRC
MUTE
3. While the main unit is powered off (STANDBY mode),
press MUTE on the remote control for 5 seconds.
4. The ID SET message appears on the main unit’s OLED display.
5. To finalize the link, turn the main unit’s power on while the
subwoofer’s LINK LED blinks.
• The main unit and the subwoofer are now linked (connected).
• The LINK indicator (blue LED) on the subwoofer is turned on.
• You can enjoy better sound from the wireless subwoofer by
selecting the sound effect. (See page 20)