Alignment and adjustments, Warning, Cycle count mode – Samsung DV457EVGSWR-AA User Manual
Page 4: Software revision mode
4
ALIGNMENT AND ADJUSTMENTS
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
Cycle Count Mode
Definition of Cycle Count Mode:
-
This mode is to bring up the total number of cycles that User have carried out.
How to enter:
DV455*
-
Press the Mixed loaded bell key in Service Mode.
DV457*
-
In service mode, press the “1” button
Software Revision Mode
Definition of Software Revision Mode:
-
It is to retrieve its software version
How to enter:
DV455*
At Service Mode, press Temp until it sends out a beeping sound
ex) In case of “U1 05”, U1 means major version “U1”, 05 means minor version “05”.
-
If press Temp key In Software Version Mode, it will return Service Mode.
DV457*
-
If the unit enters service mode, the software version is displayed in the center top of the
display panel.
If you press the “2” button, the software version of the sensor board is displayed.
Technical_information-02835D-02_EN.indd 4
2012-04-26 �� 11:51:30