Jawbone 2 - Manual (Page 2)

• To
turn off the led
, press the Talk Button 5
times while in standby mode.
• To
answer an incoming call while on a call
,
press the Talk Button.
• To
change the volume
during a call, press the
NoiseAssassin Button to cycle through the
multiple volume levels.
• To
turn noiseassassin off
or back on during a call,
press the NoiseAssassin Button for 2 seconds.
note
NoiseAssassin is always
on
by default.
• Turn the Jawbone headset
on
or
off
by
pressing the Talk Button for 2 seconds.
• To
answer a call
, press the Talk Button.•
• To
reject a call
, press the NoiseAssassin
Button while phone is ringing.
4 Talk
• Jawbone’s patented NoiseAssassin requires
contact with your face. Make sure the Voice
Activity Sensor (VAS) is touching your face.
If the VAS doesn’t touch your cheek, the headset
will not work properly.
• Jawbone comes with 4 earloops and 3 earbuds
for maximum comfort.
• To wear Jawbone, tuck earloop behind your ear,
place earbud snugly inside your ear, and rest
Voice Activity Sensor on your cheek as shown in
the diagram.
3 Fit
to manually put your headset in pairing mode
• Hold down the Talk Button and NoiseAssassin
Button for 2 seconds until the indicator light
flashes RED + WHITE. (Headset must be
powered off to initiate).
• Pairing mode lasts for 3 minutes, or until
successful pairing.
• Your Jawbone headset automatically goes into
pairing mode the first time you turn it on.
• In pairing mode, the indicator light flashes
RED + WHITE
to pair for the first time
• Turn on your phone’s Bluetooth setting
• Press the Talk Button for 2 seconds
• ‘Search for New Devices’
• Select Jawbone
• Enter passcode ‘0000’
2 Pairing
5 More
• To
initiate voice dialing
, press the NoiseAssassin
Button for 2 seconds in standby mode and then
speak a command.
• To
redial last number
called, triple-tap the
NoiseAssassin Button.
For additional information visit jawbone.com/support
©2008 AliphCom. All Rights Reserved.